Revitalizant EX120 for diesel engine
XADO EX120 Revitalizant for diesel engines. A concentrated oil treatment designed for restorative wear protection of serviceable diesel engines, including turbocharged and high-load applications.
- 20% greater active-agent concentration than XADO’s standard gel revitalizant
- Compatible with common engine-oil types, including synthetic oils
- Designed to support worn friction surfaces by forming XADO’s protective ceramic-metal layer during operation
Ordering note: the required number of syringes depends on engine oil-system capacity. Passenger-car treatments commonly require multiple syringes, so check capacity before ordering.
For mechanically serviceable engines only. Critical wear, broken parts or major loss of compression still require diagnosis and repair.
Effects
- Rebuilds worn metal and protects against future wear for 62,000 miles
- Reduces fuel consumption (up to 30% at idle, up to 15% under normal driving)
- Increases oil pressure in the system to the nominal value
- Levels and increases compression in cylinders
- Increases engine power and improves acceleration
- Decreases levels of noise and vibration by 10 times
- Increases service life of parts by 2-3 times
- Protects engine from metal loss caused by cold starts
- Improves the engine operation right after the first 50-100 km (approx. 20-60 miles)
- Enables the engine to run for up to 300 km (approx. 200 miles) in the event of substantial loss of oil in the system
Application
The engine treatment is conducted in three stages:
Stage 1: Warm up the engine to the normal working temperature, then turn engine off. Ensure the syringe is at room temperature so the contents flow freely. Empty the contents of the syringe into the engine oil reservoir. Start the engine and let it idle for 5-10 min.
Stage 2: Repeat the procedure after 100-250 km (approx. 60-150 miles) of run.
Stage 3: Repeat the procedure after 100-250 km (approx. 60-150 miles) of run.
The treatment is considered complete after 1,500 km of run (approx. 950 miles).
Dosage
Oil system capacity, l 3-10 11-20 21-30 Number of syringes (8 ml), pcs. 3 6 9 Treatment procedure 1+1+1 2+2+2 3+3+3 Number of syringes for new engines 2 4 6 Note
Changing oil is NOT recommended until the treatment is fully completed.
It is possible to conduct the treatment at idle: 4 hours of idling is an equivalent to 200 km (approx. 125 miles) of run.
New engines with odometer readings up to 20,000 km (approx. 12,000 miles) should be treated in one stage.
Engines that have undergone a complete overhaul should be treated in the usual three-stage manner.
The protective metal-ceramic coating will form on any operative mechanical parts; however, if an engine part being treated is in critical condition (100% wear), the worn part should be replaced.
Keep out of reach of children. Avoid contact with skin and eyes. If swallowed, seek medical advice immediately and show this container or label. Avoid release to the environment; refer to special instructions/Material Safety Data Sheet.
Material Safety Data Sheet is available for professional user on request.
The typical car with an oil capacity of up to 10 quarts requires 3 syringes for a complete treatment.
Package
Syringe 8 ml
